HEAVY LIFTING EQUIPMENT

MORE on HIGH LIFT WHEEL DOLLY >

High Lift Wheel Dolly

SKWD 500 | SKWD 500E | SKWD 501 

  • Lifting forks incorporate rollers to allow rotation of wheel assembly to align wheel studs.
  • Lifting forks tilt through activation of hand pump for precision bearing alignment. Tilt is 10 degrees above and 4 degrees below horizontal.
  • Heavy steel framing assembled to the highest industry standards.
  • Fully hydraulic operation.
  • Powered by pneumatic or 12 VDC.
  • Nylon rollers for minimal maintenance.
  • Non-destructive nylon front roller wheels.
  • Swivel rear dolly wheels to ensure tight turning radius.
  • Nylon strap included to secure wheel assembly to dolly.
  • Protective steel cover to prevent foot injuries and increase stability.
  • Easily relocated and position by one man.
MORE on TRANSMISSION JACK >

High Duty Transmission Jack

skTJ 401 | skTJ 401E | skTJ 402 

Capacity : 3 500 lbs
Lifting range : From 37 to 74 inches
Lifting speed : 30 inches per minute 
Powered by : Pneumatic or 12 VDC
Table tilting capacity : ±12 ° on both axies

  • Fully hydraulic lifting system.
  • Dual stage cylinder.
  • Heavy steel framing assembled to the highest industry standards.
  • X-Style base frame for added stabilityand easy access.
  • Precision height alignment by means of independent hand pump.
  • Built in air pressure regulator and lubricator.
  • Lifting table adjusted by means of (2) large crank handles.
  • 2 Nylon straps included to secure transmission to table top.
  • Easily relocated and position by one man.
  • Full swivel rear dolly wheels to ensure tight turning radius with mechanical locks.
  • Non-destructive nylon frontroller wheels.

GET ONE OF OUR REPRESENTATIVE ANSWER YOUR HEAVY LIFTING EQUIPMENT QUESTIONS


MORE on MID-RISE LIFT >

Mid-Rise Lift

skmr 36e | skmr 36p 

  • Fully hydraulic lifting system.
  • 18 000 lbs per column.
  • Up to 30 inches lift.
  • 105 seconds to full extension.
  • 24 feet quick connect hydraulic hose link.
  • Usable by pair or single mode.
  • Easily relocated and positioned by one man.
  • Powered by pneumatic or 24 VDC.
  • Security locking system with 1•••” step, independent of lifting mechanism.
  • Heavy steel framing assembled to the highest industry standards.
  • Nylon slides for minimal maintenance.
  • Non-destructive nylon front roller wheels.
  • Non-destructive nylon springassisted rear dolly wheel.
MORE ON SUPPOT STANDS >

Support Stands

  • Heavy steel framing assembled to the highest industry standards.
  • Ergonomic design promotes health and safety in the work place.
  • Tall stands easily located through tilt and roll by utilizing dual rubber wheels and stowaway handle.
  • All stands over 36 inches in height include a spring inside the lifting support tube to reduce possible hand pinching.
  • Contact heads available in a variety of styles.
  • Some models allow 6 inches of fine adjustment through incorporation of an ACME screw.
  • All models feature adjustment and locking pin secured to the stand by steel cabling.
  • Short stands are relocated by hand.